[walkerman180]

sometimes when i close the door the windows don't automatically roll all the way up the extra half inch or so

any one else have this prob?

[1BADSTANG]

mine work mint every time.

[TheUNZippee!]

Read your manual. There is a way to reset the short drop glass.

[07vert]

It happened to me yesterday.
Opening and closing a few (4-5) times resets the computer.

[ZOOTOXIN]

Originally Posted by 1BADSTANG mine work mint every time.

+1 and it's an 03

[1FastFox]

Courtesy of E...

Originally Posted by Emay Found my documentation in an email exchange I had about 15 months ago. FORD: 2005-2007 Mustang ISSUE: Some 2005-2007 Mustang vehicles may exhibit issues with the functional power window features including one touch up, short drop, and bounce back. ACTION: Follow the Service Procedure steps to correct the condition if the root cause is incorrect or no window initialization of the Smart Window Motor. SERVICE PROCEDURE Perform a de-initialization procedure of the smart motor / side window glass, followed by re-initialization procedure. NOTE: WINDOW RE-INITIALIZATION MUST BE PERFORMED WITH THE DOORS CLOSED. NOTE: ON CONVERTIBLES, WINDOWS COULD BOUNCE BACK IF THE SIDE GLASS IS OUT OF ADJUSTMENT. REFER TO THE WORKSHOP MANUAL (WSM), SECTION 501-11. NOTE: CHECK TO MAKE SURE THAT THE DOOR SEAL OR MIRROR SEAL IS NOT ROLLED OVER OR BINDING. ALSO, THAT THERE IS NO OBSTRUCTION IN GLASS SEALING AREA AND THE GLASS FIT AND/OR REGULATOR MECHANICAL FASTENING IS NOT LOOSE. DE-INITIALIZATION PROCEDURE De-initialization (un-learning) of the smart window motor clears the memory of the module and shuts off the One-Touch UP, Bounce Back and Short Drop functions. The smart window motors can be de-initialized in two (2) different ways: Disconnect the battery cable from the battery WHILE THE WINDOW IS MOVING. Remove the window motor fuse from the Power Distribution Box WHILE THE WINDOW IS MOVING. After performing one of the above procedures, the smart motor must be re-initialized, see Initialization Procedure. INITIALIZATION PROCEDURE INITIALIZATION MUST BE PERFORMED WITH THE DOOR CLOSED! (For convertibles, top and the quarter glass must be in the up / closed position.) From the window switch, perform the following steps without stopping: Operate the window UP and stall for 2 seconds. (Hold The Switch) Operate the window DOWN and stall for 2 seconds. (Hold The Switch) The smart window motor will be initialized and one-touch-UP and Short Drop will be operational. Cycle the window glass an additional five (5) times to set the window "Soft Stop" for the down position. TIP - VOLTAGE RANGE OF OPERATION: 9-16 VOLTS (AT THE MOTOR) The smart motor will ONLY function in the 9-16 volt range; if the voltage at the smart motor drops below 9 volts, the window may not function properly or prematurely stop moving If the voltage drops below 9 volts while the motor is moving, the motor will become de-initialized (one-touch UP and Short Drop will be inoperable) If the motor becomes de-initialized due to low voltage, see initialization procedure. for instructions

[TheUNZippee!]

Short drop glass (Front windows only)
In order to improve door efforts and sealing, your vehicle is equipped
with short drop glass. This feature lowers the glass when either door is
opened. The glass returns to its closed position when the door is closed.
Proper operation of the short drop glass requires that the windows be
calibrated. Though your windows will have been calibrated before
your vehicle is delivered to you, it is possible for the windows to
lose calibration. If a window loses its calibration, your short drop
feature will lower the window, but will not raise it again when the door is
closed. To re-calibrate the window, pull the switch up to raise the
window until it completes its travel and hold the switch up for 2
seconds. Another possible effect of lost calibration is that the feature
may not lower the window. To re-calibrate the window in this case, lower
the window until it completes its travel and hold the switch down for 2
seconds. Immediately after releasing the window down switch, pull the
switch up to raise the window until it completes its travel and hold the
switch up for 2 seconds. Perform Short drop re-calibration with
doors closed only.

[1FastFox]

Not to Zippy on that one Zipster... Day late and 6 inches short...

[1FUN4RD]

Originally Posted by 1FastFox Not to Zippy on that one Zipster... Day late and 6 inches short...

[TheUNZippee!]

Originally Posted by 1FastFox Not to Zippy on that one Zipster... Day late and 6 inches short...

Actually I had that posted about an hour or so ago, but I dunno where the post went.

[G.T. Rags]

Originally Posted by TheUNZippee! Actually I had that posted about an hour or so ago, but I dunno where the post went.

theres a problem with the server......... every once in a while a post gets sent to a random thread........

NBA used to bitch about it and everyone called BS on him and said he was just being a NBGay...... turns out the lil Richard Simmons lookalike was right, vbulletin is haunted

[TheUNZippee!]

Originally Posted by 96GTRagTop theres a problem with the server......... every once in a while a post gets sent to a random thread........ NBA used to bitch about it and everyone called BS on him and said he was just being a NBGay...... turns out the lil Richard Simmons lookalike was right, vbulletin is haunted

So I'm not going crazy then. lol

I was beginning to wonder maybe in my flu-ridden haze if perhaps I had clicked the wrong button. lol

[G.T. Rags]

Originally Posted by TheUNZippee! So I'm not going crazy then. lol I was beginning to wonder maybe in my flu-ridden haze if perhaps I had clicked the wrong button. lol

u might have.......

run a search on all post made under ur name and have a looks...... if u posted it and it popped up somewhere else, she'll show face