[06silvergt]

I have an 06 GT with these parts sitting in my garage;

JBA long tube headers

JBA off road H pipe

MMR cold ar intake

Ford racing delete plates

4:10 gears

Steed Pulleys

Aluminum driveshaft

I've been reading about the JBA long tubes throwing codes because of the loctaion of the O2 sensors. Since they are back a little further they aren't heating up correctly. I called Brenspeed and asked a guy there about this and he said I would have to weld the bungs closed and install new ones closer to the tubes. I tried to ask another question and I was told to hold on and the guy hung up. I called back and left several messages but I got no reply, I guess they don't do JBA long tubes.
For all you guys with JBA long tubes and a good tune where did you get it? Also, I have to drive it about 10 miles to get the gears installed, would it hurt to drive it with any or all of these parts installed until I applied the proper tune?

Thanks,
John

[Bhblondguy]

you'll throw a few codes after the jba install and o/r h pipe, the cold air intake will also make your engine die when you push in the clutch if your car is manual. you will def. need a tune as soon as possible...

when I put the c and l racer cai on my car it ran like crap until I had it tuned, died everytime i pushed in the clutch at a stoplight.

the pipes and headers don't have to worry too much about those for now. hope that helps

[MaverickMLFD371]

bamachips or brenspeed got my votes

[Regency 2007]

were are you located?

[06silvergt]

I live in Pittsburgh. I did call Brenspeed but Seth told me I would have to change the location of the O2 sensors or they couldn't help me.

[06RedfireGT]

You will be fine driving with the exhaust but not withthe delete plate or intake. The car will run real rough. Just get a tune for Bama and install the delete plates while they are doing the gears.