[na svt]

There are thousands of mustangs with small diameter dampers and piggyback pulleys so they can't all be bad.

Originally Posted by NewMach123 Hey guys, I am new to the site. I have been looking around for a little over a month or so as I recently acquired an 04 Mach 1.....I will post pics in the next couple weeks hopefully. I was wondering what would be a great start for mods, I was planning on putting Borla catback exhaust with a CAI, not sure which one I want yet but leaning towards K&N setup. Sound like a good first start?

Conflicting opinions aren't uncommon when talking about which mods are good/bad or safe/unsafe and this thread shows just that. Do your research and hit up some other sites like SVTP, ModularFords, and Corral.net, teh more opinions you get the better. There are a lotta mods you can do, some will cost a lot of money and add no power while others provide great bang for the buck. I'm sure you'll get many suggestions and weeding thru them can be difficult if you haven't already figured that out. Good Luck!

[futureMACH1racer]

Originally Posted by na svt There are thousands of mustangs with small diameter dampers and piggyback pulleys so they can't all be bad. Conflicting opinions aren't uncommon when talking about which mods are good/bad or safe/unsafe and this thread shows just that. Do your research and hit up some other sites like SVTP, ModularFords, and Corral.net, teh more opinions you get the better. There are a lotta mods you can do, some will cost a lot of money and add no power while others provide great bang for the buck. I'm sure you'll get many suggestions and weeding thru them can be difficult if you haven't already figured that out. Good Luck!

Don't forget the Mach1 Registry.. Also remember to take what you read off of forums with a grain of salt. These are people's opinions. There is no better solution than going to a reputable shop, and seeking their guidance. After all, they didn't get their reputations, or keep their doors open by being hacks, or wrong....