[Iownastang]

Anybody heard about the new edelbrock pro port cnc heads coming out soon they are fully cnc ported at edelbrock.I got there new catalog at the goodguys car show in nashville last week.Then I called edelbrock yesterday and they said that they were going to start doing cnc work in house instead of sending them out to chapman racing in idaho.The guy I talked to said they were in the shop earlier porting on some castings,and that they should be on the market in the next couple of months.For small block ford they come in 170cc intake runner 1.94 1.60 valves 60cc combustiuon chamber P/N 51319 assembled and the 190 comes with 2.02 1.60 valves with a 60cc chamber as well P/N 51309, they do not come unassembled as of right now.They are not listed on edelbrocks sight yet,the pro port raws are but they are not the same head, they are just an unfinished victor jr or glidden victor head.These should be a very nice set of heads and should flow pretty nice as well.I am bored settin here in knoxville tn so I thought I might post this thread.

[neverfastenough1]

I'm sure they will be tested in a mag soon enough. We shall see how they do.