| ![]() | ||||||||||||
| |||||||||||||
|
|||||||
![]() |
|
|
|
LinkBack | Thread Tools |
|
|
#1 |
|
Regular
|
fuel filter
how do I get the fuel filter off ?
__________________
2001 mustang gt 5 speed Full bolt ons with 4.10 gears. 1965 Mustang 302 with 4 Barrel edelbrock 600cfm, T5 transmission, Hurst short throw shifter. In the process of restoring it... |
|
| Sponsored Links | |||
Advertisement | |||
|
|
#2 |
|
Resident Bubblehead
2000 Mustang GT
Join Date: Nov 2006
Location: Haymarket, VA
Posts: 5,954
![]() ![]() ![]() iTrader: 2 reviews
|
remove the 2 clips for the fuel lines going into and out of the filter, then disconnect the hoses. then loosen the clamp holding the filter in place. make sure you remember which way the filter is oriented so you install the new one correctly. that's it. i'm assuming you've already relieved the fuel pressure or you know how to do it? make sure you do that before you disconnect any fuel lines. if you don't know how to relieve the fuel system pressure, here's how:
1. unplug the electrical connector for the fuel pump switch. it's located in the trunk, on the left side. 2. once the switch is disconnected, start the engine and let it shut off by itself (due to lack of fuel) that's all there is to it. once you're done replacing the fuel filter, make sure you reconnect the fuel pump switch. if the button on the top of the switch popped up while you were doing this, just push it to reset it. |
|
|
|
#3 |
|
Enthusiast
Join Date: Oct 2007
Location: Upstate SC
Posts: 922
![]() iTrader: 0 reviews
|
you need a special fuel line disconnect tool.....any auto parts store will have it. And you relive the fuel pressure by taking off the little black plastic cap from the front end of the fuel rail on the passenger side and depress the little schrader valve.
__________________
Accufab 75mm tb & plenum MRT h-pipe Flowmaster catback FRPP king cobra clutch FRPP aluminum driveshaft FRPP 4.10 gear TA Perfromance girdle Steeda tri-ax shifter Moser 31 spline axles FRPP C Springs |
|
|
|
#4 |
|
Regular
|
ya i figured it all out. I had to get the special tool to get the filter off. I poped it off, the new one back on, then started it up. Simple and easy after you get the right tool
__________________
2001 mustang gt 5 speed Full bolt ons with 4.10 gears. 1965 Mustang 302 with 4 Barrel edelbrock 600cfm, T5 transmission, Hurst short throw shifter. In the process of restoring it... |
|
|
|
#5 |
|
MM Fanatic
2000 GT
Join Date: Dec 2006
Location: Lynnwood, Washington
Posts: 4,258
![]() ![]() ![]() iTrader: 4 reviews
|
is it the same tool that takes the strainer from the fuel rail?
|
|
| Sponsored Links | |
Advertisement | |
![]() |
| Thread Tools | |
|
|
Threads Similar to: fuel filter
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lucas fuel injector cleaner and fuel filter | Saleen0101 | Modular Mustangs | 0 | September 25th, 2007 04:09 PM |
| Fuel Filter | 06RedfireGT | The Clubhouse | 12 | August 13th, 2007 02:29 AM |
| fuel filter | JASonic | V6 Mustangs | 11 | July 15th, 2007 11:04 PM |
| fuel filter | JASonic | V6 Mustangs | 2 | February 25th, 2007 12:30 PM |
| Fuel Filter 96 GT | Beatz | 96-98 | 1 | September 12th, 2006 06:06 PM |