[03StangGT]

Just ordered a chin spoiler and grill delete kit. any pre installation prep necessary? any pointers to making it an easy install? suggestions?

[AndrewA.]

get some one to help with the chin spoiler...my tape kept falling off and an extra pair of hands would have made the simple job..simple

[AndrewA.]

oh ya and just use a short bolt washer and nut for the chin spoiler..thro that plastic snap crap away

[03StangGT]

ok any thing else? is the grill delete pretty simple?

[AndrewA.]

Dont know i did a billet grill and that was a HUGE pain..these two little screws to get on..but taking off the factory honey comb is simple

[03StangGT]

ok thanks for the help. hopefully they will come in within the next couple days

[MineralGreyGT]

grill delete is the easiest mod, just remember to reuse the screws on the bottom of the stock grill.

[JaxnsGT]

getting to the 4 screws on the bottom of the stock grill is a PITA. The chin spoiler definitley use screws or bolts, First time i barely hit a curb with mine it popped 5 of the push pins int the middle and the front of it sagged down.

[takiller]

ive been told the grill delete isnt that bad to put in but the chin spoiler def good if you have an extra pair of hands. and def go with the bolts, mines bolted in and ive smacked it a good couple of times and its still holdin up strong.

[03StangGT]

ok thanks guys, hopefully theyll arive monday

[00redgt]

yeah dont ues the plastic thing that come with the chin,i barely hit an bump stop this morning an snapped 3 of them,came home an replaced with some nuts an bolt for better support

[2000stangGT]

for the grill delete you might need anti torx screws. and use them again so no one steals your pony

and on the spoiler use bolts and wing nuts so it doesn't go anywhere

and yes a 2nd pair of hands helps

[JStang14]

def dont use the snap ins for the chin spoiler, i was putting machboy's on and i broke over half of them just putting them on...of course it was freezing in my garage too, i got some black-headed screws and put it on that way

[gills99stang]

I bought the Mach 1 chin spoiler for my car, ditto on what these guys said about not using the plastic screws, get some stainless steel nuts and bolts.

I drilled extra holes under the car for the bolts. When lining up the spoiler to the car, get someone to help you and then tape it in place using masking tape.