[03StangGT]

does anyone have these installed. i was wondering how much it cost to put in. i was looking into getting electric ones and wondered if its something i could do myself. thanks

[workinprogress]

if you can weld then you can do them...weld well. and do wiring

[03StangGT]

its been about two years since ive welded but in sure i still can just as good. is there any clearance problems with them?

[workinprogress]

not that i know of, there is alot of space under there, i would put them right after the x pipe so that it can still do its job of equalizing manifold pressure

[03StangGT]

ok i have to wait to see how much i get from my taxes. do you have an extimate on how much a shop would charge

[workinprogress]

if you can do the wiring, i would say about 100-150

[Doc8224]

Do you have an aftermarket cat-back? If not, and you are gonna have a shop put the cut outs in, you could get a nice cat back for what it will cost to buy E-cutouts and have them installed. Just my .02

[workinprogress]

good call doc^^^

[03StangGT]

i do have a after market catback. where exactly do they mount?

[Doc8224]

You can put them wherever you want, after the X will be the best place. Do you have an aftermarket mid pipe too? You do know you are not going to gain anything but noise with cutouts right?

[03StangGT]

yea i think they sound bad ass. idk about the aftermarket mid pipe tho

[Doc8224]

If the mid pipe is the stock one (2 1/4" ugly H pipe with 4 cats) then get an O/R X or O/R H. That will give you a great sound improvement and a nice boost in power, all for less then you will spend on E-cutouts and having them installed.

[03StangGT]

ok thanks!