![]() | ![]() | |||||||||||
| ||||||||||||
|
|||||||
Discussing KEYLESS FOB NOT WORKING OR A NEW ONE NEEDS SETUP in the Electronics Forum. For my 95 Mustang GT I just bought a new fob for the Ford keyless ... Modded Mustangs is the premier Ford Mustang Forum on the internet. We discuss all aspects of the Ford Mustang on the forum. Registered Users do not see the above ads. Please Register - It's Free! |
|
|
LinkBack | Thread Tools |
|
|
#1 |
|
Newbie
Join Date: Nov 2006
Location: Yuma AZ
Posts: 13
|
KEYLESS FOB NOT WORKING OR A NEW ONE NEEDS SETUPNewer ford cars (OBDII types) use the ignition to go into program mode by turning the key on-off about 8 times, for older fords this does not work. So after searching I found the program connector, it is in the trunk on the driver side. You have to pull out the whole liner on the inside of the quarter panel this is held by a couple of plactic nuts and a few pop-push plastic rivits. So there it is a grey connector on the bracket that holds the computer. turn the key to on (don't start). Short the two pins in the grey connector momentary and the door locks will cycle, push a button on the fob and they cycle again, if you have more then one fob repeat for the others before you turn of the ignition. When you turn off the ignition the door locks cycle on last time. Your fob(s) should work now. ![]()
__________________
Fast or slow I like to make them go, Big or small I will drive them all. |
![]() |
| Thread Tools | |
|
|
Threads Similar to: KEYLESS FOB NOT WORKING OR A NEW ONE NEEDS SETUP
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Keyless entry | 00GTstang | 99-04 | 24 | September 10th, 2007 09:05 PM |
| My keyless entry stopped working! HELP! | alex892007 | Electronics | 4 | April 15th, 2007 03:49 AM |
| Ford keyless entry | jbennett05 | Electronics | 1 | January 3rd, 2007 08:49 PM |
| Keyless entry and more | trueballerisme | Electronics | 11 | December 24th, 2006 01:05 AM |
| Car Keyless Entry | Dennis-96GT | Electronics | 15 | November 10th, 2006 09:34 PM |