| Home | Register | FAQ | Members List | Calendar | Blogs | Garage | Gallery | Search | Today's Posts | Mark Forums Read |
| | |||||||||||
| ||||||||||||
|
|||||||
Discussing still throwing codes :( in the Engine Forum. Ok, a little while back i was throwing these codes: P0135 Upstream Heated Oxygen Sensor ... Modded Mustangs is the premier Ford Mustang Forum on the internet. We discuss all aspects of the Ford Mustang on the forum. Registered Users do not see the above ads. Please Register - It's Free! |
|
|
LinkBack | Thread Tools |
May 5th, 2008, 12:17 PM
|
#1 | ||
|
Hardcore Enthusiast
2000 V6 Mustang
Join Date: Oct 2007
Location: PA
Posts: 2,015
|
still throwing codes :(P0135 Upstream Heated Oxygen Sensor Heater circuit fault - Bank No. 1. P0155 Upstream Heated Oxygen Sensor Heater circuit fault - Bank No. 2. P0741 Torque Converter Clutch Circuit Perf/Stuck Off Now i changed all four of my O2 sensors to Bosch Premiums, and i also flushed the tranny and drained the torque converter and put in synthetic ATF. After this was done, i cleared the engine codes...then disconnected the negative on my battery to reset the comp.....and a few days later the same code came back. Could the wires be bad that connect to the O2 sensors...and could i have a bad solenoid that is getting stuck on my torque converter?
__________________
|
||
 |
| Thread Tools | |
|
|
Threads Similar to: still throwing codes :(
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problems fixed, yet still throwing codes HELP | shadow5403 | V6 Mustangs | 3 | May 7th, 2008 10:26 AM |
| Engien light on...throwing these codes | shadow5403 | Drivetrain | 2 | April 6th, 2008 09:42 PM |
| Engine light on, but throwing no codes? | shadow5403 | V6 Mustangs | 10 | April 4th, 2008 02:24 PM |
| Throwing Codes! | Garhfer | 99-04 | 2 | March 7th, 2007 09:21 AM |
| Computer throwing BAD CODES | 00SoSlow | General Tech | 6 | June 22nd, 2006 09:13 PM |
