Modded Mustang Forums banner

Reaction score
18

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews About

  • · Resident Know-it-all
    Joined
    ·
    2,970 Posts
    Yes there is. I've seen it on the dyno. The major advantage of a big bore 347(363) vs a Windsor bored out is the difference in reciprocating weight and diameter of rod and main bearings. The 8.2 deck 3.4" stroke based engine will always make more power and rev quicker. The advantage of a Windsor is of course the block is stronger.

    · Registered
    Joined
    ·
    0 Posts
    hello
    just joined helping friend with his stang seen you have a 72 demon. wondring i have a 72 in kit form disassembled number matching vin/eng/ 4 speed car, selling to complete other demon ttbb if interested i can send vin and pics selling cheap 2900 ,hs scat pac hood only ned windshield and rear center section to b complete have the 9.91 gear
    thanks Rob
    715 297 3971 located in centran wisconsin 270 miles from chicago

    · Registered
    Joined
    ·
    0 Posts
    i read that u ran a p600b with stock fuel rails, and same pumps as i have also and same presure regulator, did u have to install larger fuel lines with that though? im getting ready to install my p600b and want to make sure i have all the necessary components, i went with trick flow track heat top end kit though, but i dont think i want more than 420 rwh to keep the engine in tact
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top