| ![]() | ||||||||||||
| |||||||||||||
|
|||||||
![]() |
|
|
|
LinkBack | Thread Tools |
|
|
#1 |
|
Newbie
|
power window problems. please help.
my passenger side window stopped working months ago on my 2002 v6 coupe. i bought a new motor and regulator. that wasnt the problem. i got a new switch. that wasnt it either. and all the fuses in my car are good. i tried researching it but i couldn't find anything going past the switches. can someone please help me figure out whats wrong? any tips or advice would be great. thank you.
|
|
| Sponsored Links | |||
Advertisement | |||
|
|
#2 |
|
The soul stealing Ginger
|
Can you hear anything going when you press the switch? like a humming noise or anything? if you have a voltmeter probe the points in the connector that plugs into the switch on the door and see if you even have power going to it, try to narrow it down a little more.
|
|
|
|
#3 |
|
Hardcore Enthusiast
Join Date: Feb 2007
Posts: 1,262
![]() ![]() iTrader: 0 reviews
|
Ford has a set of wiring diagrams that are separate from the shop manual. These can be obtained from Helm publications. With the wiring diagrams and a voltmeter it should be possible to trace the wiring. If you don't know how to do that you might want to take it to an automotive electrical shop.
|
|
|
|
#4 |
|
Custom User Title
2001 Mustang V6
and suddenly slow.
Join Date: Nov 2010
Location: Picayune, MS
Posts: 593
![]() ![]() iTrader: 0 reviews
|
Mine did the same thing. Take it to a glass shop, and say you need them to epoxy the clips back onto the bottom of the window. I can almost promise you that it's nothing electrical. Simple 2 hour job
__________________
![]() Mods Thus Far: Lowered 1.5" on front, Flowmaster 40's w/catted H pipe dumped before axle, 6k HID's, Decklid blackout, Grille delete, Smoked headlights, Tri-ax w/Rock crusher handle. |
|
|
|
#5 |
|
Newbie
Join Date: Apr 2011
Location: Topeka, KS
Posts: 32
![]() iTrader: 0 reviews
|
My driver side window was completely off the track (on the left side) and the window was separated from the epoxy glued clip but it still went up and down. It was just crooked and made a bit of noise from it being loose in the door.
|
|
|
|
#6 |
|
The soul stealing Ginger
|
my passenger side is crooked and does not have alot of power going up, sometimes when it gets near the top i have to push it up the last literally 2cm to close all the way in one corner to avoid wind noise,...i should look into this.
|
|
|
|
#7 |
|
I'm doing it wrong
04 Grand Cherokee
Join Date: Mar 2010
Location: South Eastern, Mass
Posts: 5,211
![]() ![]() ![]() ![]() iTrader: 0 reviews
|
Just throwing this out there. My drivers side window stopped working a while back. I took my door panel off and pulled the fonzy maneuver down by where the bottom speaker is. (hit it with my hand a couple times) and problem has been solved.
I have also heard of a couple others doing the same thing and it worked.
__________________
Formerly known as Demon_54 "I feel the same way about disco as I do about herpes." - Hunter S. Thompson
|
|
|
|
#8 | |
|
The soul stealing Ginger
|
|
|
|
| Sponsored Links | |
Advertisement | |
![]() |
| Thread Tools | |
|
|
Threads Similar to: power window problems. please help.
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power Window Problems | 86GTStang306 | 5.0 Mustangs | 2 | September 22nd, 2010 10:35 PM |
| 1998 power window motor has power then installed its dead?? | crabbymaddy | V6 Mustangs | 2 | September 19th, 2010 07:26 PM |
| Power window | 01KnightRiderGT | 99-04 | 17 | April 7th, 2010 05:12 PM |
| Power window! | Serefire | V6 Mustangs | 29 | April 10th, 2008 09:06 PM |
| Power Window Problems | Replica R | Audio/Video | 4 | October 12th, 2006 11:51 PM |