HS-CAN and MS-CAN Bus Issue
New to the forum. I have a 2011 GT. Both CAN buses are reading 120 ohms at the DTC connector. It should read 60 ohms with the PCM and IPC connected. Has anyone run into this problem? The only module that has both buses is the IPC. There are no connectors in any of the harnesses that have both buses going through which leads me to believe it is in the IPC.
Any help would be greatly appreciated.
You'll probably want to check out the modular section of the board, this one is for the old pushrod 5.0's
|All times are GMT -4. The time now is 09:56 AM.|
powered by vBulletin ©2000 - 2019, Jelsoft Ent. Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.