|Topic Review (Newest First)|
|August 30th, 2018 03:16 PM|
You'll probably want to check out the modular section of the board, this one is for the old pushrod 5.0's
|August 29th, 2018 08:58 AM|
HS-CAN and MS-CAN Bus Issue
New to the forum. I have a 2011 GT. Both CAN buses are reading 120 ohms at the DTC connector. It should read 60 ohms with the PCM and IPC connected. Has anyone run into this problem? The only module that has both buses is the IPC. There are no connectors in any of the harnesses that have both buses going through which leads me to believe it is in the IPC.
Any help would be greatly appreciated.