Modded Mustang Forums banner
1 - 10 of 10 Posts

·
Registered
Joined
·
1,747 Posts
Discussion Starter · #1 ·
now that im putting 4v heads on my gt block the compression is going to drop more than i was thinkinh.. is it still safe to spray at this low off a cr until i have some money to but a some boost?

and another side question.. will the gt exhaust fit cobra manifolds?
 

·
Premium Member
Joined
·
9,751 Posts
way back when, when we didn't know any better, a lot of us were spraying at way lower compression than that with no problem's. you'll be fine if you choose to spray it.
 

·
Registered
Joined
·
1,747 Posts
Discussion Starter · #5 ·
ok so how do i fix the exhaust problem? weld that **** on there?
 

·
Premium Member
Joined
·
9,751 Posts
the mid pipe should bolt to the 4v manifolds, you just cant use 2v exhaust manifolds, you'll have to use 4v manifolds.
 

·
Registered
Joined
·
1,747 Posts
Discussion Starter · #7 ·
ok well as long ass my midpipe will bolt up to the 4v headers then im good!
 

·
Registered
Joined
·
7,991 Posts
spray and compression arent related
they work hand in hand

nitrous does soo much better on motors with more cr

but 9-1 on a pump gas motor is more than fine
 

·
Registered
Joined
·
1,747 Posts
Discussion Starter · #10 ·
aight hatch thanks... does anyone know if a 99-01 cobra intake will fit 96-98 cobra b heads?
thanks
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top