Modded Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,237 Posts
Discussion Starter #1 (Edited)
While I had to complete this car in a hurry towards the end, having changed so many things on it and even doing this kenne bell. Nothing replaced the look of joy on my father's face when he saw this beauty, and the reaction he had when I realized I'd given him a full setup with supercharger and all. We delivered the car end of September.
He certainly wasn't ready for that haha but I was so glad to be able to complete this for him and make a big difference in his life.
The car is doing wonderfully and has more to come. For us here. Full efforts are going into the beast, the green mustang. But this project was priority!


The installation was not the worst but i have a lot of pictures from the installation and some video of course i put together ! Check it out subb up etc !

225331


Moved over to the gates green belt which is holding up nice. I am pushing about 8lbs boost in summer conditions . Using the accufab throttle body .

Intake tube is a 90mm maf with a terminator cobra JLT intake pipe . Kenne bell requires that the intake is in the fender , to get the colder air of course. I went with a few 4 inch elbows to get things lined up then run the filter in the fender itself up high . It works well this way and is away from water


225332


225334
 

·
Registered
Joined
·
2,237 Posts
Discussion Starter #2
225333


Some fine cleaning after all the installation was completed . Now i've also had to make modifications to the fuel setup . As well .

<iframe width="560" height="315" src="
" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>
 
1 - 2 of 2 Posts
Top