Modded Mustang Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 · (Edited)
All four plastic linkage rod retainers are crumbled or gone. Looks cheap and easy to replace, but ... how in the heck do I get back there?? I can barely see from the sides, much less actually work. Do I actually have to remove the intake manifold just to replace these four little snaps? Looks pretty rough to reach back there AND see what I'm doing. Tips and tricks needed!

'03 3.8L
 

·
Banned
Joined
·
15,799 Posts
wana know what I do?
every lower intake I get that someone sends me and has the IMRC box still on.
I dont even grab a wrench. A decent hammer and knock the sh!t outta the box. then pull the bolts, then the butterfly bolts(goodluck not screwing up the head) then just pull the rod right out. Plug the hole. Takes about 20min maybe
 
1 - 3 of 3 Posts
Top