Modded Mustang Forums banner
1 - 1 of 12 Posts

· Powered by LSx tears
21,964 Posts
It's hard to tell exactly what I'm looking at from the picture of the hole, but it looks like an accessory bolt hole on the end of the head? If that's what it is, put a heli coil and a bolt in it.

As far as your intake, if you "torqued the **** out of it," I hope it's not an aluminum one, or you took a great chance of ruining it. It should be torqued to 20 ft. lbs, using the proper torque sequence, and if the bolts are backing off, you need new lock washers. Look at the lock washers, and if they're flat, they're bad.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.