Modded Mustang Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
423 Posts
Discussion Starter #1
im not gonna buy the other mustang that i was lookin into so im gonna build up my notch

my goal is to get over 400hp at the crank and my list of mods that i want to do are as follow

351 short block all forged internals 10:1 compression

edelbrock performer heads 60cc

underdrive pullys

hooker headers

flowmaster exhaust

all msd ignition

edelbrock super victor intake manifold

holly 750cfm carburator

and a big cam

aproximatly how much horse power will that make any sugjestions will be appriciated
 

·
Registered
Joined
·
423 Posts
Discussion Starter #2
i just realized i spelt aproximate wrong (i probably just did again)
 

·
all motor
Joined
·
576 Posts
351 with 10-1 comp, good heads, cam and intake will make WAY more than 400 crank h.p. much closer to 400 ACTUAL rwhp imo
oh- and with a notch you'll be happily in the low 11s motor i think with a conservative estimate if ur suspension isdone
 

·
Registered
Joined
·
1,572 Posts
i'd get performer rpm heads instead of performers
 

·
Registered
Joined
·
5,029 Posts
that super victor is gonna be to big for stock performer heads I would go vic jr it would be a better match
if i was him i would just go ahead and get victor heads and intake
 

·
Registered
Joined
·
423 Posts
Discussion Starter #7
i was told about a new set of edelbrock heads that are suppost to be the best of the best

there called the edelbrock extreams or something like that
 
1 - 8 of 8 Posts
Top