Modded Mustang Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,725 Posts
you will also need the air compressor to hold valves up when you change springs.when I did my springs, I removed the cams and reinstalled the caps then used the otc tool with a piece of 1" alum. pipe cut just a little longer than cams. waaaay easier! plus you don't cut the **** out of your knuckles on the cam lobes, them are sharp!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top