Modded Mustang Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
356 Posts
Discussion Starter #1
I have searched around but have not seen a definite answer. Will a Bullitt intake fit on a 4.6 with npi heads? Or will I need pi heads to go along with it? I currently have a pi intake and welded the water passages instead of the silicone method. Might be an interesting upgrade to work with my supercharger (if I can solve all of the ducting issues).
 

·
Registered
Joined
·
678 Posts
It shouldn't be any different than putting a PI intake on NPI accept it is made of aluminum.
 

·
Registered
Joined
·
356 Posts
Discussion Starter #3
Thanks for the reply. Another question, will the stock strut tower brace still fit?
 

·
Registered
Joined
·
164 Posts
probably not. Not the end of the world if you don't have it on there
 

·
Registered
Joined
·
356 Posts
Discussion Starter #5
Not end of world but being a vert I am looking for as much help as I can get.
 

·
Registered
Joined
·
2,364 Posts
if you are wanting to go with a bullit intake manifold, might i suggest another route that might be more beneficial? go with an svo intake manifold. the bullit manifold was based off the svo manifold and i believe the svo manifold fits on the npi heads iirc but i could be wrong and it COULD be specific to the svo heads.
 

·
Rollin' 18/ pushin' 2
Joined
·
8,333 Posts
The svo intake will fit either the svo heads or the npi heads.
 
1 - 7 of 7 Posts
Top