Modded Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
Bought a dynotech aluminum ds from late model restoration and it arrived today. Tag connected to the tranny flange says 11-13 gt but the sticker on the ds says 05-10 gt so I'm freaking out now.

late model guy told me to measure the flanges as that's the only difference between the two? I'm calling dynotech in the morning.

 

·
good with the steel.
Joined
·
244 Posts
Its going to either bolt up or not. Use a micrometer to measure the stock flange holes. See if the measurements match up.

Hows the quality on that dynotech?
 

·
Registered
Joined
·
109 Posts
Discussion Starter #3
May not meet the rape ewok. Measurements dynotech gave me match an 11-13 (05-10s have much shorter shafts). Quality is good besides Cletus slapping on a 05-10 sticker.
 
1 - 3 of 3 Posts
Top