Modded Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I am building a 310 roller motor and was wondering if there are any little tricks when putting it together to gain HP? Also if i am going the right way with the motor to build high horsepower? The motor is a mid 80's 302 taken out to a 310. i have a stock crank and stock rods with ARP everything. It has hypertectic pistons. I got a set of 3 line GT-40 heads that have the valves bored out to 1.94 and 1.600. I have a set of roller rockers on them. The cam is from lunati and its has a lift of 5.65/5.65. and i also got a fadenza Aluminum flywheel. if you could give me tech tips it would be greatly appreciated.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top