Modded Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
788 Posts
Discussion Starter #1
I am swapping from a 3.8 to a 4.6 in the summer. do I need a new k-member from a 4.6? is there a place i can get one if i need one? any ideas on where i can get on cams, heads, or pulleys for a beefed up naturally aspirated engine? I've done the 3.8, but im not familiar with the 4.6.
 

·
Registered
Joined
·
788 Posts
Discussion Starter #3
i was mostly interested in finding a k-member and a bell housing for the trans. plus the ecm.
 
1 - 3 of 3 Posts
Top