Modded Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter #1
ok as of right now im having the rear end done in the next week or two and then after that comes the shortblock. now i was told to go with a solid roller camshaft but its looking like the car might see more street than originally expected so not really sure which cam to run now and if i should go custom or off the shelf. im also tryin to pick out lifters and valve springs. btw im gonna be using victor jr heads.
 

·
Registered
Joined
·
2,950 Posts
just use a hydraulic roller cam.....that will be fine
 

·
Registered
Joined
·
277 Posts
I'm going to run a 282hr along with a set of the crane link lifters since my block wasn't a roller. the 282 is nice, and a lso a good nitrous cam if you like the squeeze........
 

·
Registered
Joined
·
4,781 Posts
Yeah, that is only like a $700 set up for lifters and cam... might as well get a solid roller for that price.
 
1 - 4 of 4 Posts
Top