Modded Mustang Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2,365 Posts
Discussion Starter · #1 ·
i bought a set of rods, bearings, rings, and pistons for a great deal ($125 shipped) to throw in my 5.4 but i just found out today that they are for an engine that is bored .050" over. dang it
 

·
Better than Drugs!
Joined
·
2,064 Posts
dang. i need some for my cobra--- all the things you have i need.but for a 4.6 pooooop
 

·
Registered
Joined
·
2,365 Posts
Discussion Starter · #5 ·
if i bore the motor out i will unshroud the valves but if i EVER mess anything up i cant bore it out anymore.....and i have to pay for it to be bored out

mayo, i have been playing with the idea of pressing the pistons off the rods and selling off the pistons. if you would be interested in the pistons, i could go that route and get the correct pistons as well as you get a brand new set as well
 

·
Registered
Joined
·
2,365 Posts
Discussion Starter · #6 ·
cant bore it out .050", if i wanted to do this i would have to resleeve it and that is just not happening.

suggestions?
 
1 - 6 of 6 Posts
Top