Modded Mustang Forums banner

1 - 5 of 5 Posts

·
raaka kone
Joined
·
89 Posts
Discussion Starter · #1 ·
Hey everyone,

Its been forever since I posted here. Reason for this post, its time for a new motor. Mine quit a few days ago, and I was looking at replacing it with a PI version from 01 GT I found.

Mostly curious for those of you who have done a full swap before, can my non pi harness and computer run the new one? The guy I found local to me already sold the harness and computer, and its a really good deal for an 80k mile engine.

Thanks.
 

·
Registered
Joined
·
4,557 Posts
Yes your harness and ecu will run the motor fine. A tune will help but its not necessary.

And welcome back.
 

·
Hardcore Enthusiast
Joined
·
1,578 Posts
Only thing you will have to do is drill and tap an additional coolant temp sensor port on the driver side of the intake manifold. 96-98 cars had two while the 99 up only had one on the passenger side.
 
1 - 5 of 5 Posts
Top