Gt40 intake 351w or Trick Flow 351w
1 - 4 of 4 Posts
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
8.8" rear end measurements...
5.0 MustangsI'm wondering, does anybody have the width measurement of a 8.8" Fox box and SN95 rear ends measured from that of the where the wheels mount up? I've read some flange measurements but I've been told that's the flange of the rear end and not actually where the tires mount up, like the outside of...- 15
- 101K
-
Anyone have a foxbody with a saleen wing?
5.0 MustangsI have a 91 GT Convertible that I want to order a saleen wing for but am trying to get a custom car cover made first. I gave them the dimensions of the wing but Covercraft still needs one last measurement in order to make the pattern for my car. How far does the wing extend out from edge of...- 0
- 198
-
94 GT clutch replacement
5.0 MustangsMy DD is begging for a new clutch. ('94 5.0L, T-5 WC, 3.73 rear) I was planning on getting this setup Ford Performance HD Clutch set but after calling a few shops, I'm questioning it. They use Luk or Valeo clutches and it'll cost me about the same to use theirs vs my list below. Using their I...- 0
- 162
-
Foxmoto28 · updated
-
88 mustang steering ??
5.0 MustangsRecently installed a clutch pedal assembly and now the steering shaft sticking out of the column seems too short...do they slide in and out? It needs to move out 1/2 inch for the bolt hole to line up with the shaft that has the u joint and rag joint on it. I've tried putting a breaker bar on it...- 3
- 276
-
Which Tremec should I get for my 351
5.0 MustangsI did talk to they guy at Hanlon motorsports back in April of this year but a lot has happened since then and though I have the printout of estimates for what we talked about, I still want to ask you guys opinion on if I need a 500 or 600? Car will be a 351 with the proper crank to make it...- 3
- 891
-
from6to8 · updated
Join now to ask and comment!