Modded Mustang Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
152 Posts
Discussion Starter · #1 ·
After I get a new set of cams for my car it will be a bit before I can get to a town where I can get my car dyno-tuned. In the mean time will my car run fine with a 91 octane tune from a hand held tuner? The tuner is a superchips tuner, and the cam is going to be a mild cam that wont be too choppy. Any advise? Thanks!!!
 

·
Registered
Joined
·
152 Posts
Discussion Starter · #3 ·
Yea thats all I hav, a host of bolt ons, TFS 44cc heads, and the soon coming cams. So ok cool thanks!
With a cam that will so what Im aiming for do I have to worry about piston clearence?
 

·
Premium Member
Joined
·
10,464 Posts
if you properly time your cams then you wont have to worry about PTV clearance.
 

·
Registered
Joined
·
152 Posts
Discussion Starter · #5 ·
Cool thanks! Ill take it back to the guys wh installed the heads, they timed the cams fine, no reason they cant do it again. Thanks again!!!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top