Modded Mustang Forums banner

1 - 5 of 5 Posts

·
MM's official Chevy guy
Joined
·
2,024 Posts
Discussion Starter #1
does any one have a wright up or can give a instructions on how to remove the lens from a new edge headlight
thanks
-mike
 

·
MM's official Chevy guy
Joined
·
2,024 Posts
Discussion Starter #2
bump
 

·
MM's official Chevy guy
Joined
·
2,024 Posts
Discussion Starter #4
Use a hammer, if that dont work, use a bigger hammer;)
lol
the problem i have is with getting the Sealant off i have heard something about putting it in the oven but i want a little more instructions, i don't just want to go throwing my headlights in there hoping i am doing it right.
 

·
MM's official Chevy guy
Joined
·
2,024 Posts
Discussion Starter #5
ok so i found out how to do it
here are the instructions i got thanks to GF
450 degrees for 10 mins, take out, and unclip tabs and seperate, clean/do whatever needs to be done, reclip tabs, put back in over at 450 for 10 mins, apply even pressure to reseal along the glue, add extra clear silicon for added protection against leaks

i am going to try it out this weekend
 
1 - 5 of 5 Posts
Top