Modded Mustang Forums banner

1 - 14 of 14 Posts

·
N/A 4v Guru
Joined
·
3,484 Posts
No its valve overlap in the N/A cams that isn't good for the boosted setups.
 

·
Registered
Joined
·
1,994 Posts
i was going with blower cams because i do want to add a vortech on ther later, but as i heard, with n/a cams there will be a boost leak or something like that right?
i honestly do not know the answer to that...

how far away is the vortech? I would personally go with custom grind N/A cams and then sell them and get the blower cams

thats just me though, either way, its better than stock :D
 

·
N/A 4v Guru
Joined
·
3,484 Posts
I wouldn't be worried about running a blower cam on a N/A setup, I wouldn't run a N/A cam with a blower setup.
 

·
N/A 4v Guru
Joined
·
3,484 Posts
Are you asking if you need to upgrad springs for stock PI cams? Or for stage 2 cams?
 

·
N/A 4v Guru
Joined
·
3,484 Posts
I don't MPH's specs, I would just get ahold of them and ask them if you need springs with their blower cams.
 

·
Registered
Joined
·
1,376 Posts
Discussion Starter #14
(from my first post my question) mmr stage 2 heads with mph supercharger cams. now will i need to upgrade the valvesprings on this? and on a car without a supercharger(not yet plannig for one) how much will you say i would make with that setup. also will have full exhaust by that time and other mods are in the sig
 
1 - 14 of 14 Posts
Top