Modded Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter #1
Just installed the crank and 6 rods and pistons crank bearings were .002 clearence and rods were the same or .0015 I can spin my rotating assembly fairly easily so far but I don't know how easy it should spin. Thought I heard 20 ft lbs, I hope that's wrong lol. Crank was just polished block was bored new forged pistons and rods
 

·
Registered
Joined
·
1,137 Posts
you should be able to turn it fairly easy with a 1/2 in ratchet
 

·
Registered
Joined
·
124 Posts
Discussion Starter #3
It does prolly just freaking out cuz I was working on it till.4 am had an.engine builder crank it over this morning and he said im golden.. He says your looking for smoothness while it rotates more than anything.
 
1 - 3 of 3 Posts
Top