can anyone tell me what i need to do to run this set up??? stock gt40p heads' corba intake' F303 cam thinking bout 70mm tb. will this set up be any good and i also have sealed power hypereutectic pistons no AC OR SOMG pump any one know how much HP this set up will make.
Help
1 - 14 of 14 Posts
Joined
·
830 Posts
what is your question
Joined
·
478 Posts
not really sure what you want to know first but 300 to 325 at best
Joined
·
478 Posts
f cam has .512 in lift and it will work with those heads and should clear stock or aftermarket pistons with no problem
Joined
·
478 Posts
most long tube headers will work fine and buy a cam kit to include lifters and valve springs matched to that cam
Joined
·
478 Posts
StangPro.com - Ford's GT-40P Cylinder Head
this is info on the gt-40 p's it should help and........ no problem
this is info on the gt-40 p's it should help and........ no problem
Joined
·
3 Posts
help
I really need help i have a 302 explorer engine with da gt40p heads i want to know can i put a f303 cam in that engine and wht springs and rockers do i must have to do that!! thanx
I really need help i have a 302 explorer engine with da gt40p heads i want to know can i put a f303 cam in that engine and wht springs and rockers do i must have to do that!! thanx
Joined
·
11,205 Posts
always use new springs with a cam swap. Springs should be match to the cam. If you going to use a cobra intake you should port it to match the 70mm Tb you want to use. Cobras only have 65mm opening. Porting it is not hard it just takes a few dollars and a few hours. You should try and stay away from all the ford motor sports 303 cams. that topic has beed discussed over and over over and over over and over over and over over and over again. Bad choice in cam, pic another one
Joined
·
21,964 Posts
How about buying a good cam, instead of a paperweight?
1 - 14 of 14 Posts
