Modded Mustang Forums banner
1 - 2 of 2 Posts

·
BWAL Is My Hero
Joined
·
15,891 Posts
Lightblade on S197forum is making 655RWHP 582RWTQ with a single 67mm Billet Ball bearing Precision. 76 is way over kill... Lightblade is doing it at 16 PSI....


This graph is 14PSI showing the difference between Ball Bearing, Billet Wheel and Journal Bearing, Cast Wheel.
WWW.S197FORUM.COM Look on post #40.
 

·
BWAL Is My Hero
Joined
·
15,891 Posts
I am a follower if the K.I.S.S. method. I would rather have a single turbo on a street car.
1. Less money.
2. Less **** to break.
3. WAY easier install.
4. Way easier maintenance when something breaks, which it will...

Ever had to take apart a TT kit to change a accessory (Power steering, alt., etc.) ? **** that noise... If you do twins, there is really no need to go bigger than 57 or at the max 62mm... Otherwise your going to be leaving some spool time on the table and I am pretty sure you don't want to run a automatic do you Mickey?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top