Modded Mustang Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
609 Posts
Discussion Starter · #1 ·
so over the weekend i replaced the axels in my 95 b/c one was out of wack..when i pulled the differential housing, i noticed that NONE of bolts that hold the ring gear to whatever the hell it is that it bolts to (about 9 bolts) were tight, and 3 of them were backed off so far that it only had about 1/16" clearance...f-ing amazing that it hasnt locked up on me...

What could have caused this. could the vibration from the bent axel i had cause the bolts to back out? anyone ever have this problem?
 

·
Banned
Joined
·
11,614 Posts
no but a diff i got off of mustank had one of them fall out and destroy the trac lok (knew this before i bought it, he didnt sell me junk), did you put them back in with lock tite?
 

·
Registered
Joined
·
609 Posts
Discussion Starter · #3 ·
no thread lock...just torqued em down good. are you supposed to use TL?
 
1 - 3 of 3 Posts
Top