Modded Mustang Forums banner

1 - 1 of 1 Posts

3,813 Posts
Discussion Starter · #1 ·
I have this distributor, its never been ran, just installed on the motor and sat there. It has a steel gear for roller cams. Only requires 3 wires to hookup (never been hooked up, wires are as from MSD), no external box needed. I still have the box it came in from MSD.This distributor will clear both the Vic Jr and the Super Vic (pictured) with no issues. Built in Rev limiter.

I'm asking $350

You can see the distributor in the attached pic:

20171228_223414 by Brett, on Flickr

MSD's info:
1 - 1 of 1 Posts