Modded Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hello, I need to replace my alternator this upcoming weekend, however when I installed Sr performance UDPs a while back, I had to shave off part of the stud supporting the alternator in order to get the pulleys to fit. Now that I need to swap out my alternator, I’m worried I’m not going to get the nut off the stud because of when I cut the end off with my angel grinder. Any suggestions on how to get the nut off?
 
1 - 2 of 2 Posts
Top