Modded Mustang Forums banner
1 - 1 of 4 Posts

· Registered
224 Posts
no doubt on the tire wear

but bet, if you're lowered, replace the rack (standard cardone rebuilt is like $80 @ o'reillys) which includes inners... The inners are like $20 each anyway so you're half way there... Then get offset rack bushings to push that bitch to where it should be...

The replacement tie rods are bandaid. If your geometry is off that bad, get replacement spindles or control arms that allow you to mount the tie rod ends an inch or 2 higher to counter the lowering
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.