Modded Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
300 Posts
Discussion Starter #1
Im doing a pi cam and intake swap on my 97 gt within the next month and I just read this page about installing the cam without removing the timing cover.

Truth about NPI vs PI

On this page it talks about using a "Anderson Tool" to hold the cam gear and timing chains in place while you swap out the cam? This would mean no removing the timing cover, which would be great. But I cant seem to find what tool this is and Im assuming that it holds the gear and chain in place and you just remove the cam bolt and swap it with the pi cam? If anyone could show me a link to where I could buy this tool is sure would make things easier :D
 

·
Registered
Joined
·
678 Posts
Do it the right way and remove the timing cover. The tool can slip and if you are lucky you end up having to take the cover off anyway and if you aren't lucky it only slips a tooth or two which ends up damaging your engine.
 
1 - 2 of 2 Posts
Top