Modded Mustang Forums banner

1 - 8 of 8 Posts

·
I Eat Baby Stangs
Joined
·
3,928 Posts
Discussion Starter #1 (Edited)
This is a video of last year at Beaver Springs dragway. This was my second fastest pass of the day, but not nearly good enough to keep up with the 5.0 GT.

my car has some traction issues, notice it chirping in every gear (trust me, not bragging) and this year at the strip with the gutted interior, it'll spin for atleast the first 60ft. I knocked .3 seconds off and gained 2 mph and still ran the same 60ft and not far off on the 1/8th mile
 

·
Banned
Joined
·
980 Posts
Put the car on a DR and you will not have any problems.
 

·
Registered
Joined
·
319 Posts
those cars will snap a axle with DR. i had a svt contour that ran 14.8's :D
 

·
I Eat Baby Stangs
Joined
·
3,928 Posts
Discussion Starter #5
There is actually a technique that works that wont break them. I actually launch at 5,000 RPM. just make sure you load the drive axles before you launch. Chances of breaking them are slim then, unless you have some serious power. and 14.8 isnt bad. the fastest time yet is a 13.2 with a 3.0 turbo making over 400 hp. he says he cant hook up.
 

·
Registered
Joined
·
79 Posts
They had to switch over and clock you with a sundial.
Half past 3 ;)
 
1 - 8 of 8 Posts
Top