Modded Mustang Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
692 Posts
Discussion Starter #1
I know that they stopped making them but i have the opportunity to buy one for $400.

Are they good?

I need one because my intake manifold cracked.
 

·
Registered
Joined
·
250 Posts
you will need a retune and depending on how YOU drive put your powerband higher. its a short run with a small plenum. for 400 its worth the risk. any more no.
 

·
Registered
Joined
·
21,024 Posts
If you don't want it, link me and I'll buy it!
 

·
Registered
Joined
·
21,024 Posts
I would buy it, only cause I'm building a high revving motor. I'm not sure what else you need
 

·
Registered
Joined
·
1,333 Posts
A new hood.... new i/c piping... fuel rails... a new tune

I had a line on a couple of the RR... I decided to go with the Edelbrock to avoid the low end and torque losses that the RR has
 

·
Registered
Joined
·
250 Posts
I have a worked over RR with a 1" spacer. i like it very much. i have a stroked engine. low-end doesnt bother me at all.
 
1 - 13 of 13 Posts
Top