Modded Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
Hey guys I'm kinda stuck here.... I'm in the process of resembling my teksid shortblock which has the 4 bolt main caps. in my Hayes manual it shows me the torque specs and the order but I just can't figure it out. if some one could please help me decifer the sequence I would appreciate it. here is what it says:
 

·
Registered
Joined
·
99 Posts
Discussion Starter · #2 ·
main bearing cap bolts (tighten first)
step 1 (tighten bolts 9, 10, 19, 20).......... 71 to 106 inch-lbs.
step 2 (tighten bolts 1 to 10) ................. 16 to 21
step 3 (tighten bolts 11 to 20) ................ 27 to 32
step 4 (tighten bolts 1 to 20) .................. rotate an additional 85 to 95 degrees


and then inside the chapter it tells me to tighten them to spec in 3 increments working from the center outwards.

IM CONFUSSED!!!
 
1 - 2 of 2 Posts
Top