Modded Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Ok, if this is a stupid question, then act like you didn't read it.

I finally got my block done and have moved on to the head. BOY! getting those springs compressed with the tool I had was a major pain in the hind end!. I had to do some grindin and bending on the compressor tool to get it to work.

My question is, When I put it back together, do I have to use those cups again? Or can I leave them on the bench?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top