Modded Mustang Forums banner
1 - 1 of 7 Posts

· Registered
591 Posts
The Wiring Harness That Goes To The Injectors Has These Small Mini Boots That Go Onto These Studs That Screw Into The Original Manifold .there Is No Place To Install These Sensors (grounds Or Whatever They Are)

Mini boots, do you mean 10 and 11 in the harness diagram? Oil pressure sender (10) is not in the intake, but the water temperature sender (11) is in front of the number 5 injector, there should be a threaded hole for it.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.