[electricblue87]

I Just Picked Up Another Stang,and I Am Installing A Explorer Manifold However The Wiring Harness That Goes To The Injectors Has These Small Mini Boots That Go Onto These Studs That Screw Into The Original Manifold .there Is No Place To Install These Sensors (grounds Or Whatever They Are) Into The New Manifold Should I Drill And Tap Holes For Them Or What?

 

[electricblue87]

yes you got it the mini boots i , the temp sender for some reason there is no hole for it in my new manifold , i thought was very strange.I think the manifold is from a explorer.I was thinking of drilling and tapping a hole into a coolant passageway

 

[electricblue87]

my bad i figured it out , these holes are the same thread, it is the act sensor that does not have a hole to go into in the new manifold.I heard you can relocate it into the air intake tube without any problems have any of you guys done that before??