Modded Mustang Forums banner
1 - 18 of 18 Posts
i dont know if the speed density will make a difference but otherwise you could on a maf car......you can spray 150 on a stock fox
 
You can do 150 on hyper pistons but it's sketchy. Sd if fine it makes no difference on a wet kit. If your for sure you have hyper pistons I'd stick to 100 shot and start working on suspension or something.
 
can i spray 150 or 100 shot on a SD 88gt f303 cam gt40p heads cobra intake and hyper pistons?????
Pick up an NOS part# 05115-II nitrous kit and go to town. Read the directions completely (twice if you need to) and make sure the kit is installed properly. Make sure you have full knowledge of what nitrous does and how to operate it. Also make sure you have all of the safety devices like blow down tube and blow off cap.

Unless you swapped a 93-95 engine in your car, you have forged pistons.
 
stock internals too?
No, not in this car but if I would have built the engine I would have did alot different.......like leave the stock crank, rods and pistons in it. I know many people that have made 500+ at the tire with stock internals. A good friend of mine made 555hp at the tire and raced the car religiously every weekend for 2 years. The engine is still alive too.
 
<-- my boy ran high 10s in his 85 mustang with a cougar motor ( stock bottom end complete with cast pistons ) a cam , ported stock heads, rpm intake, and 750 carb and a 200 shot for the longest time. it was his daily driver and he went thru a bottle of nitrous almost every week.
 
1 - 18 of 18 Posts