i think i finally have all my parts needed to do it now, so i figured i would go ahead and start up the thread for it. thoughts and advice is welcome. i got my windstar upper from chris at CRT RACING PERFORMANCE | .
Approximate parts list so far...
-Windstar upper intake
-custom built bracket for iac relocation (still need to build)
-bracket to hold throttle cable
-gaskets for upper intake
-upper intake bolts
-coil pack bracket
-shaved iac
-3/8 extra line to run vacuum hoses
-T for hooking in my boost gauge
-Precision Garrett GT4088 turbo
-Tial 38 mm wastegate - 4.4 psi and 10.3 psi spring (running the 4.4psi spring for now
-HKS Bov
-3" mild steel single exhaust dump
-single 3" exhaust dump pipe routing to underneath the car then through a 3" Magnaflow muffler that dumps right before the axle
-OBX Intercooler 32" x 12" x 3" large bar and plate intercooler
-boost gauge and air/fuel gauge (planning to get a wideband eventually)
-miscellaneous stuff - K &N Filter, silicone hoses and lines, T bolt clamps, Oil feed lines, Oil drain lines
-SCT BigAir2800 MAF
-drill bit and tap for the oil pan
-02 extenders
-header wrap
-breathers
-overflow tank
-new spark plugs - 2 colder
as i think of anything else i missed i will add it to the list....
the install will probably start saturday afternoon
Approximate parts list so far...
-Windstar upper intake
-custom built bracket for iac relocation (still need to build)
-bracket to hold throttle cable
-gaskets for upper intake
-upper intake bolts
-coil pack bracket
-shaved iac
-3/8 extra line to run vacuum hoses
-T for hooking in my boost gauge
-Precision Garrett GT4088 turbo
-Tial 38 mm wastegate - 4.4 psi and 10.3 psi spring (running the 4.4psi spring for now
-HKS Bov
-3" mild steel single exhaust dump
-single 3" exhaust dump pipe routing to underneath the car then through a 3" Magnaflow muffler that dumps right before the axle
-OBX Intercooler 32" x 12" x 3" large bar and plate intercooler
-boost gauge and air/fuel gauge (planning to get a wideband eventually)
-miscellaneous stuff - K &N Filter, silicone hoses and lines, T bolt clamps, Oil feed lines, Oil drain lines
-SCT BigAir2800 MAF
-drill bit and tap for the oil pan
-02 extenders
-header wrap
-breathers
-overflow tank
-new spark plugs - 2 colder
as i think of anything else i missed i will add it to the list....
the install will probably start saturday afternoon