Modded Mustang Forums banner
Cancel
Create thread New Garage Forums

installing glowshift gauges

Jump to Latest
1 - 7 of 7 Posts

sam03rc

· Registered
Joined
·
292 Posts
Discussion starter · #1 ·
going to be installing a set of glow shift gauges this next week in my time off in my 2000 gt. need some help with finding some wires under the dash. Ive not a lot of electric wiring so any help will be great. from the instructions they gave me need a switched 12v, constant 12v, and 12v headlamp wire so they will dim at night. and the ground i know i can just find a spot on the dash to tie into.

also i test fitted the pillar pod and i have to trim the bottom for the wires to come out but not sure how im going to route all the wires from there. anyone whos done this how did you route your wires.

thanks
 
#2 ·
I have glow shift guages and the install was kind of a pain in the ass. For the switched source use this http://www.summitracing.com/parts/pco-0956pt?seid=srese1&gclid=CPCs6Kq3ursCFYg-MgodYiQA_Q and crimp it to the end of the wire then under your dash in the fuse box use the radio fuse. For the constant switch i used a t tap connector to the cig lighter. I have the glow shift pod and i got it to fit without trimmig it, it fits kinda shitty and i do not reccomend it but for 25$ new i could not say no lol.

---------- Post added at 01:02 PM ---------- Previous post was at 12:50 PM ----------

to route your wires peel back that weatherstrip, then run your wires in the gap between the dash and the pillar
 
1 - 7 of 7 Posts
About this Discussion
6 Replies
2 Participants
Last post:
sam03rc
Modded Mustang Forums
posts
6.3M
members
83K
Since
2005
A forum community dedicated to all Ford Mustang owners and enthusiasts. Come join the discussion about performance, racing, builds, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
96 - 04 Modular Mustangs 5.0 Mustangs New Members Introductions Classic Mustangs