Well I should be going this weekend to pick up a bare 05+ aluminum block. Got a good idea on a set of rods, and a crank, still yet to decide on a set of pistons. (If anyone has any suggestions, it would be appreciated)........anywho back on topic. This will be a fairly high comp. motor, not too much though. 10.5.1 or so. Already have the heads taken care of, along with the Comp SPR stage 3 cams, springs, phasers, etc. What bearings are most people going with these days?? I'm pretty sure I can get Factory Ford stuff for about the same price if not cheaper than any aftermarket, BUT if the aftermarket bearings are better, thats what i'll go with. (talking about mains and rods)........all the gaskets and stuff I get pretty cheap. Also looking into the MMR 3v oil pump kit. Yeah, yeah, MMR sucks, I know.
If anyone has any input or questions let em' rip............I'm always looking for ideas. This will be a "budget" build, and maybe a healthy dose of nitrous. Ok scratch that "maybe", it WILL have nitrous.
If anyone has any input or questions let em' rip............I'm always looking for ideas. This will be a "budget" build, and maybe a healthy dose of nitrous. Ok scratch that "maybe", it WILL have nitrous.
