Modded Mustang Forums banner

Help Me Get Into the 13's

1.4K views 9 replies 7 participants last post by  ReverendDexter  
#1 ·
I am planning out my mod list to get my slow ass npi into the 13's.

Current Mods:
UPR Offroad X
Pypes 2.5" Cat Back
CAI
Steada Tri-Ax's

Future Mods:
75mm TB
Plenum
4:10's

Will i break 13's with those mod's or is more stuff needed. Dont say Pi swap b/c i am doing that after summer.
 
#8 ·
I am planning out my mod list to get my slow ass npi into the 13's.

Current Mods:
UPR Offroad X
Pypes 2.5" Cat Back
CAI
Steada Tri-Ax's

Future Mods:
75mm TB
Plenum
4:10's
I run a 13.8@99mph in my slow ass NPI. on DR's 14.0@99 without them.

I have

Cattless X-pipe, Mac catback.

BBK metal CAI, Steeda Underdrive pulleys, 3.73 gears, steeda tri-ax, Superchip chip, coil packs and wires. So yeah...i doubt 13's but deff low 14's. Depends on how you drive too, i would consier myself on the higher side of good. :D

I have PI intake, PI cams, BBK TB and plenum, Spec Stage 1 clutch, Upper nad lower C/A's now but no track times.

i also have a 75shot installed but never used. haha.
 
#10 ·
98SilverBullet said:
any suggestions on suspension packages? Wouldnt mind dropping the car an inch or two. Also, would drag radials fit on the stock rims? I have RFT on the Svt's so i rather not change them out.
Eibach, Maximum Motorsports, Griggs, Steeda, I think even Edelbrock is selling drag suspension kits these days.