Should be right in front of the engine close to the intake manifold/thermostat area I think...

 

Yes.

It's in the coolant crossover in the intake manifold, and I believe that it is on the passenger side. I distinctly remember it's passenger side because I had to extend it for the Cobra crossover's sensor on the driver side.

That is the coolant temperature sensor.

The coolant level sensor is on the bottom of the coolant reservoir tank, driver side, right by where the hose goes down to the thermostat.

Look just above the lower rad hose.

 

Look just above the lower rad hose.

 

I don't know about the others but mine is in the coolant tank. When my coolant got low then it got stuck. This is not a recommeded repair but I took a rod and went through the filler tank to loosen up the float. It worked. The SEL never came back.

 

I was thinking coolant level. My bad.

 

Yeah, the OP didn't specify which sensor he was looking for, just "coolant sensor."

Technically there's two that fit the description, the temperature one is in the intake manifold crossover, and the level is in the reservoir tank.

Hopefully that answers your question somewhat OP.

 

If I unplug the coolant LEVEL sensor my SEL won't come on will it? I just posted about this recently. My coolant level is good but that damn light is on the cluster

 

My float was stuck and always had the coolant light. I unplugged mine and turned the light off. I just keep an eye on my coolant.

 

The one on the intake manifold.


Thanks!

 

So is the float attached to the lid cause of so my lid has nothing hanging from it,lol